Flat Tire? Three’s the Charm (Tire Repair)
June 7, 2026
For most drivers, at some point you’re going to have a flat tire. Depending on how it was damaged, it may have to be replaced. But sometimes, a repair will do the trick, as long as the puncture isn’t on the sidewall and the hole is smaller than ¼ inch/6.35mm in diameter. Here are the three common ways your tire can be fixed.
One way is to put a plug in the hole. Since most tires are damaged by running over sharp objects such as screws and nails, the small hole from which the air is escaping is on the part of the tire that touches the road. If it’s in the sidewall, it most likely can’t be fixed.
In the plug method, a technician inserets a rubber plug. It is covered with some sticky, gluey stuff, and is pushed into the hole from the outside. That plugs the hole and stays in place, thanks to the glue. Friction from driving heats it up and seals the deal.
Another method is to patch the hole. For this, your tire has to first be taken off the vehicle, then off the rim so the technician can get access to the inside. There, they’ll clean the inside surface around the hole and apply a rubber patch with an adhesive on it. This type of patch works well, and because of the extra steps and complexity, costs more than having your tire plugged.
There’s also a combination of those methods just described, the plug-patch. It is, in essence, a type of patch with glue on it that has a plug sticking out of it. The plug is inserted into the tire from the inside and pulled through the hole from the outside, drawing the attached patch tight against the tire’s inside surface. The last two methods can’t be used if the hole is near another repair or the sidewall.
The good news is if it’s fixed properly, your repaired tire should give you good service.
TLC Custom Exhaust Brakes & Tires
1735 N Main St
Royal Oak, Michigan 48067
248-541-8300
www.tlcautocareroyaloak.com
Need Service?
More articles from TLC Auto Care

Something to Latch On To (Hood Latch Safety)
October 25, 2026
The other day, a driver was trying to open his vehicle's hood so he could add some windshield washer fluid. But when he pulled the hood release inside the car, nothing happened. Usually, opening any hood is a 2-step process. You pull the hood release (which is usually a handle under the dashb... More

Ready, Set, COLD! (Getting Vehicle Ready for Winter)
October 23, 2026
When the temperatures plunge, your vehicle better be ready because it faces a whole new set of challenges. Rubber stiffens, glass fogs, fluids freeze. Just thinking about it can get your heart beating faster. So here are some tips for getting ready for those inevitable colder temperatures. Ma... More

Why Timing Belt Maintenance Can Save Your Engine
October 11, 2026
One part of your vehicle you probably never think of is the timing belt. It coordinates the rotation of the crankshaft (which converts the up and down motion of the pistons into rotation motion) and the camshaft (which opens and closes your engines valves). Its vital that the timing of these mov... More
